LIVARNO home 1002-W Instrucciones De Uso Y De Seguridad página 35

Do not point the motion sensor towards
„
trees, bushes or areas where moving
animals can be detected�
Take into account that the motion sensor
„
responds primarily to movement across its
field of view and not so sensitively to
movement directly towards or away from it�
Mounting the outdoor spotlight
RISK OF ELECTRIC SHOCK! Incorrect
electrical installation or a power supply
voltage that is too high can potentially cause
electric shocks� Failure to take account of
that risk endangers not only yourself but
other people as well�
You should only have the product installed
„
by a qualified electrician.
When drilling the fixing holes, take care to
„
avoid drilling through wiring, cables or
pipes (e�g� water or gas pipes)�
Make sure the power supply is
„
disconnected during installation� Switch off
the circuit-breaker for the circuit concerned
or remove the fuse� Safeguard it against
being switched on again (e�g� by
displaying a warning notice)�
Observe the correct polarity when
„
connecting the wires to the terminal strip
� Refer to Figure C for details of how to
6
connect the wiring/supply cable to the
terminals�
Make sure that the mains power supply is
„
switched off�
The outdoor spotlight can be mounted
„
either on a straight wall or on a corner
using the wall bracket
Please note: make sure that you mount the
wall bracket the correct way round� Refer to
Figure F for guidance�
With the wall bracket
„
mounting position, mark the positions on
the wall for the fixing holes using either the
guide holes (for mounting on building
18
corner) or guide holes
straight wall) (see Figs� E and F)�
(see Fig� F)�
16
in its intended
16
(for mounting on
17
Drill two holes (dia� 6mm) and insert the
„
matching wall plugs
Screw the wall bracket
„
or corner mounting) in place by inserting
the screws (25mm)
holes / and firmly tightening them.
17 18
Check that the wall bracket is fixed firmly in
place�
Unscrew the gland nut
„
spotlight�
Remove the screws
„
and pull it away far enough to be able
12
to access the terminal strip
the cover plate�
Feed the power supply cable first through
„
the gland nut , then through the cable
11
grommet , and finally through the cover
15
plate before starting installation�
12
Connect the power supply cable to the
„
terminal strip � Make sure that the
6
individual cable cores are correctly
connected� Take care to ensure that the
earth conductor
9
the other conductors so that if the cable is
torn away from the outdoor spotlight, the
earth conductor comes away last� Connect
the neutral conductor
marked N and the live conductor
terminal marked L so as to avoid incorrect
installation and consequent damage to the
product or personal injury (see Fig� C)�
Secure the connecting lead (inc� outer
„
sleeve) with the strain-relief clamp
Fig� C)�
Feed the terminal strip
„
casing and screw the cover plate
onto the outdoor spotlight�
Position the cable grommet
„
cover plate and nut so as to obtain the best
possible seal and fix it in place by
hand-tightening the gland nut
Slot the outdoor spotlight onto the wall
„
bracket from above and screw it to the
16
bracket using the two screws (10mm)
(see Fig� G)�
Note: The screw heads of the cover plate
(see Fig� F)�
20
(for straight-wall
16
through the guide
19
from the outdoor
11
from the cover plate
14
attached to
6
is made longer than
to the terminal
10
to the
8
(see
7
back into the
6
back
12
between the
15
�
11
21
GB/MT
35