Brandt BCR190SLIM Manual De Instrucciones página 7

DUAL ALARMS OPERATION
Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 / Alarm 2
1. In clock time state, press
 The AL1 indicator light will illuminate and the hour digits will flash on the display.
2. While the hour digits are flashing, set hours for alarm 1 by repeatedly pressing
/.
 Press and hold / for fast setting.
3. Press
 The minute digits will flash.
4. Whilst the minute digits are flashing, set minutes for alarm 1 by repeatedly pressing
/.
 Press and hold / for fast setting.
5. Press
 "OFF" will flash on the display.
6. Whilst "OFF" is flashing, set the alarm to wake to the desired mode by repeatedly
pressing /.
rd = wake-by-radio
bu= wake-by-buzzer
OFF= alarm off
7. Press
 The AL2 indicator light will illuminate and hour digits will flash on the display.
 Follow steps 2 to 7 to set the alarm 2.
8. When the alarm 1 or 2 is sounding, the AL1 or AL2 indicator light will flash.
9. The alarm will sound for 3 minutes at the preset time on each day and come back
again after 9 minutes. The alarm will last for 1 hour.
To stop the alarm, Press
time on the following days.
Snooze function
When the alarm sounds, press
again after the set snooze duration.
NOTE: If your second alarm activates while the first alarm is
sounding or it is in the snooze mode, the second alarm will override
the first alarm (the first alarm will be reset to come on the next
day).
.
to confirm.
to confirm.
to confirm.
or . The alarm will come on again at the set
. The alarm will be turned off and come on
EN-5