Truma DuoControl CS Instrucciones De Uso página 15

– If gas system exhibits a leak, close the gas cylinder valve
and have the gas system repaired immediately by an expert;
do not open the gas cylinder valve until repair is complete.
– After the check is complete, be sure to turn the test valve
back (90° counter-clockwise until it will turn no further) and
replace the protective cap.
– Screw the threaded cap back onto the test connection.
Maintenance
The DuoControl CS gas pressure regulation system is mainte-
nance free.
In Germany, the gas system must be retested every 2 years by
a liquid gas specialist (DVFG, TÜV, DEKRA). The test must be
confirmed on the respective test certificate (G 607).
In countries where testing is not mandatory, we recommend
that the gas system is tested every 2 years for your own
safety.
The pressure regulating devices and hoses must be replaced
with new ones no more than 10 years after their date of
manufacture (every 8 years if used commercially). This is the
responsibility of the operator.
Accessories
High-pressure hoses
see page 68
1.5-metre connection hose
for connecting external gas cylinders
– connection G.5 for Germany –
(part no. 50020-61300)
Replacement gasket
for high-pressure connection M20 x 1.5 (G.13)
(part no. 50020-76300)
Remote indicator (including EisEx)
shows the removal status from inside the vehicle
(part no. 50210-01)
EisEx regulator heating
(part no. 53101-01)
Angle union 90°
(part no. 50020-56000)
Additional kit
required when gas cylinders separated by more than 100 cm
(part no. 50020-61100)
Gas remote switch
for shutting off the gas supply from the vehicle interior
GS 8 (part no. 57013-01)
GS 10 (part no. 57023-01)
15