DeWalt DC415 Manual De Instrucciones página 17

All manuals and user guides at all-guides.com
4-1/2" (114.3 mm) Cutting Wheels
Type 1 guard Type 1 guard
backing flange backing flange
abrasive cutting wheel diamond cutting wheel
clamp nut
Mounting Guard
MOUNTING AND REMOVING GUARD
CAUTION: G uards must be used with all grinding wheels,
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. The tool may be used without a guard only when sanding with
conventional sanding discs. D
guards intended for use with depressed center wheels (Type 27) and
hubbed grinding wheels (Type 27). The same guard is designed for use
with sanding flap discs (Type 27 and 29) and wire cup brushes. Grinding
and cutting with wheels other than Type 27 and 29 require different
accessory guards included with tool. A Type 1 guard is provided for use
with a Type 1 wheel. Mounting instructions for these accessory guards
are included in the accessory package.
1. Open the guard latch (L), and align the lugs (M) on the guard with the
slots (N) on the gear case.
M
clamp nut
N
2. Push the guard down until the guard lugs engage and rotate freely
in the groove on the gear case hub.
3. With the guard latch open, rotate the guard (H) into the desired
working position. The guard body should be positioned between
the spindle and the operator to provide maximum operator
protection.
15
WALT model DC415 is provided with
E
L
H