Installing And Removing The Battery Pack - DeWalt DC415 Manual De Instrucciones

All manuals and user guides at all-guides.com
4. Close the guard latch to secure theguard on the gear case. You
should not be able to rotate the guard by hand when the latch is
closed. Do not operate the grinder with a loose guard or the clamp
lever in open position.
5. To remove the guard, open the guard latch, rotate the guard so
that the lugs are aligned with the slots and pull up on the guard.
NOTE: The guard is pre-adjusted to the
diameter of the gear case hub at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting
screw (O) with clamp lever in the closed
position with guard installed on the tool.
CAUTION: If the guard cannot be
tightened by the adjusting clamp, do not
use the tool. To reduce the risk of personal
injury, take the tool and guard to a service center to repair or replace
the guard.
CAUTION: To reduce the risk of damage to the tool, do not tighten
the adjusting screw with the clamp lever in the open position.
Undetectable damage to the guard or the mounting hub may result.
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose; 1/4" (6.35 mm) thick
wheels are designed for surface grinding while 1/8" (3.17 mm) wheels
are designed for edge grinding. Cutting can also be performed by
using a Type 1 wheel and a Type 1 guard.
OPERATION
WARNING: To reduce the risk of serious personal injury,
depress the lock-off button and remove battery pack before
making any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.

Installing and Removing the Battery Pack

NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (I) into the tool handle, align the base of the
tool with the rails inside the tool's handle and slide the battery pack
firmly into the handle until you hear the lock snap into place.
To remove the battery pack from the tool, press the release buttons (J)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
O
Switch
LOCK-OFF BUTTON AND
TRIGGER SWITCH
Your cut-off tool is equipped
with a lock-off button (B).
To lock the trigger switch,
press the lock-off button as
shown. When the lock-off
button is depressed to the
lock icon, the unit is locked.
Always lock the trigger
switch when carrying or
storing the tool to eliminate
unintentional starting.
16
J
I
UNLOCKED
B
LOCKED
A