sunjoe 24V-MPSWVG-LTE-SJG Manual Del Operador página 9

2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
Fig. 2
3. The battery will take approximately 5 hours to charge.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
Push lock button
Battery pack
Fig. 1
Battery
indicators
m
WARNING!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
m
WARNING!
Do not insert the battery if it is not
completely assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and completely
assembled or with damaged or missing parts could result in
serious personal injury.
Fitting/Changing the Blade
m
CAUTION!
Always wear heavy-duty gloves when
handling the cutting blade. Mount the blade very carefully
so as not to impair the safety and efficiency of the tool. If in
doubt, contact an authorized Snow Joe
or call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
1. Switch off the reciprocating saw and remove the battery
before doing any work on the tool or the blade.
2. It's recommended to remove the branch jaw clamp before
assembly. Press the end of the clamp locking button and
at the same time pull out the branch jaw clamp from the
saw (Fig. 3).
Fig. 3
Branch Clamp locking button
jaw clamp
9
+ Sun Joe dealer
® ®
customer service center at
®