DeWalt DW625E Manual Del Usuario página 25

E N G L I S H
Connecting a dust extractor (fig. A & K)
The dust extraction adapter (33) consists of a main
section (34), a clamping piece (35), a cutter plate (36),
two screws (37) and two nuts (38).
• Slide the clamping plate (35) onto the main
section (34) from the front.
• Fit the screws (37) and nuts (38).
• Insert the cutter plate (36) from the bottom and
rotate it until it clicks in place.
• Mount the unit to the router base.
• Connect a dust extractor hose to the dust
extraction adaptor (33).
• Loosen the screw in the top of the router and fit
the hose guide as shown.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Always move your Router as indicated in
fig. L (outer edges/inner edges).
Prior to operation:
• Check that the cutter is correctly installed in the
collet.
• Select the optimal speed using the electronic
speed control dial.
• Set the cutting depth.
• Connect a dust extractor.
• Make sure the plunge limiter is always locked
before switching ON.
Switching ON and OFF (fig. A & G)
• ON: pull the switch (1) UP.
• OFF: press the switch (1) DOWN.
Loosen the plunge limiter and allow the
router carriage to regain its rest position
before switching OFF.
Using the guide bushes (fig. J)
• Secure the template to the workpiece using end
clamps.
• Select and install an appropriate guide bush (31).
• Subtract the diameter of the cutter from the outside
diameter of the guide bush and divide by 2. This is
the difference between template and workpiece.
en - 6
All manuals and user guides at all-guides.com
Guiding off a batten
Where an edge guide cannot be used, it is also
possible to guide the router along a batten clamped
across the workpiece (with an overhang at both ends).
Freehand routing
Your Router can also be used without any sort of
guide, e.g. for signwriting or creative work.
Routing with pilot cutters (fig. B)
Where a parallel guide or guide bush are
inappropriate, it is possible to use pilot cutters (24)
for cutting shaped edges.
Consult your dealer for further information on the
appropriate accessories.
These include collets (1/4-1/2"), a depth stop and
router table for use in inverted position, finger
jointing tools for dovetail and finger jointing jigs,
dowel jointing templates, guide bushes (17-40 mm),
guide bushes, guide bush holders and guide rails in
various lengths.
Maintenance
Your D
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
If the workpiece is not thick enough,
place it on a piece of waste wood.
Make shallow cuts only!
Use cutters with a max. diameter of 6 mm.
WALT Power Tool has been designed to
E
20