Technical Specifications - cecotec FORCECLIMA 9050 Manual De Instrucciones

ENGLISH
There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
The cooling
mode, there are other sources of
effect is not
heat.
good.
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed on
Big Noise.
a flat surface.
Compressor Overheat protection is activated.
does not work.
The distance between the
machine and the remote control
is too far.
The remote
control does The remote control is not aligned
not work. with the direction of the remote
control receiver.
Batteries are dead.
The pipe temperature sensor does
Displays 'E2'.
not operate properly.
The room temperature sensor does
Displays 'E1'.
not operate properly.
NOTE: If problems not listed in the table occur or recommended solutions do not work, please
contact the Technical Support Service of Cecotec.

8. TECHNICAL SPECIFICATIONS

Model: ForceClima 9050
Product reference: 05261
Rated input power: 1010 W
Voltage and frequency: 220-240 V ~ 50 Hz
Cooling capacity: 9000 BTU/h | 2270 Fri/h | 2.64 kW
Refrigerant: R290/350g
Operating pressure | Suction: 0.6 MPa | Discharge: 1.8 MPa
Maximum pressure: 3.0 MPa
Air flow: 350 m /h
3
Made in China | Designed in Spain
36 FORCECLIMA 9050
Avoid direct sunlight.
Close doors and windows, and add new air
conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the air conditioning on a flat and hard
place (to reduce noise).
Wait for 3 minutes until the temperature is
lowered, and then restart the machine.
Let the remote control get close to the air
conditioning, and make sure that the remote
control directly faces to the direction of the
remote control receiver.
Replace batteries.
Check the pipe temperature sensor and
related circuitry.
Check the room temperature sensor and
related circuitry.