Safety Instructions - Kerbl FastHeat Digital Instrucciones De Uso

Instructions for Use - FastHeat Digital
EN
1. General
These instructions for use, along with the instructions on how to use the equipment safely, are intended for the attention of the operator /
user. Please read the instructions carefully and note the regulations and relevant information before putting the device into operation.
Keep the instructions for use in a safe place for future reference!
Warnings
! Take care when using the calf's milk heater - the container and the warmed liquid are hot!
! Do not place on objects or surfaces that are sensitive to heat
! The calf's milk heater is still hot even after being switched off after use
! Never remove the film from the display and the housing. Never remove the type plate.
! Never operate the device unsupervised
Declaration of conformity
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental requirements
and other relevant stipulations of Directive 2004/108/EC and 2006/95/EC.
The CE mark confirms compliance with the Directives of the European Union. The declaration of conformity can be viewed by visiting http://
www.kerbl.de.
2. Purpose / correct use
The calf's milk heater is intended for warming milk and feed prepared using water. The calf's milk heater must not be used for other purpo-
ses, in particular to prevent the freezing of water in feeding troughs and to warm up corrosive liquids. In the event of incorrect use or modi-
fications to the device, the manufacturer's warranty and liabilities shall be deemed invalid.
3. Overview of the control elements and description of the device
This overview can be found on the jacket of these instructions for use. "B1" indicates, for example, the picture containing the description of
the control elements.

4. Safety instructions

General safety instructions
• Ensure that the voltage specified on the type plate matches the voltage of your power source.
• Before each use, check that the device, and in particular the power cable and the display film are intact. Damaged parts should only be
repaired by a qualified professional or the manufacturer. Faulty components can cause severe injury to the operator.
• Do not operate the device if it, or one of its components, is faulty.
• The device may only be connected to mains sockets which are isolated separately via a circuit breaker (FI).
• For safety reasons, always disconnect the mains plug before decommissioning the device, cleaning, modifying or maintaining it!
• Do not use the connection cable to pull out the plug or to carry the device around.
• Ensure that the connecting cable does not come into contact with hot surfaces, heat, oil or sharp edges.
Damaged connecting cables can cause fires, short-circuits and electric shocks.
• Do not use power boards. This device is extremely powerful - there is a risk of fire!
• Protect the connecting cable and hang it onto the integrated cable holder. See picture B4.
• National and international safety, health and occupational safety regulations must be observed and complied with.
• Only use original accessories and spare parts.
Children and infirm individuals
• Always keep the device in a safe, dry place out of the reach of children
10