Task Screen - J.P. SELECTA Digitheat-TFT Serie Manual De Instrucciones

INSTRUCTION MANUAL
Internal oven tempe- Temperature
rature. set.
100ºC
95ºC
Ramp
2ºC/min
Fig 7.3.1. Run screen operating at one tem-
perature.
100ºC PROG 0 RAMP
95ºC
2ºC/m
Step: 2
75ºC 01:00
100ºC 03:00
180ºC INF
100ºC 03:00
100ºC 03:00
Fig 7.3. Run screen operating with tempera-
ture profi le.
Step temperature
set.
Red: Step number
Temperature
Yelow: Waiting.
actual.
Verde:
Blanco:
100ºC PROG 2
Step: 1
95ºC
Nº step on
Last ramp run.
running.
Fig 7.3.2 Working screen.
J
.P. SELECTA s.a.u.
CODE 80308 REV 0

7.3 TASK screen

There are two operation modes:
•
•
Press on
7.3.1 Operation at a temperature
•
•
01:00
01:00
•
•
7.3.2 Operation with a temperature profi le
•
•
Time 01:00
00:53
•
2 08:00
OFF
•
OFF
OFF
OFF
02:13
Reading stored.
Reading not stored.
RAMP Time 01:00
2ºC/m
00:53
Step set
time.
Step elapsed time.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
Feb/2015
Working at a unique temperature.
Working according to a pre-programmed temperature profi le.
to change the operation mode.
Select the set point temperature by pressing on the temperature indica-
tor.
Select a temperature increase ramp if you want to increase it in a slowly
way.
The value 0ºC/min makes that the ramp increases as fast as possible.
Select an operating time. This time starts to count down when the tem-
perature reaches the set point.
The 0ºC value sets a continuous operation.
Start by pressing on this icon:
Temperature profi les must be previously programmed from the «PRO-
GRAMMATION» display.
Select a profi le (from 0 to 9) by pressing on keys:
Start by pressing on the icon:
In the temperature box (top-left corner) the current temperature and the
set point are indicated.
(It can be modifi ed without notice)
Tel 34 937 700 877 Fax 34 937 702 362
Page: 18