Athena GET CDI Serie Guia página 7

D. ACCESSORIES INSTALLATION
MAP SWITCH INSTALLATION
REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Install
Switch to the handlebar.
2.
Connect MAP Switch
faston terminals to the
MAP Switch expansion
cable faston terminals.
3.
Connect the Map
switch expansion cable
to the GET CDI unit EXP
connector.
ATTENTION: After the installation, check that the wiring
does not obstruct the free movement of the handlebar in
both directions or interfere with the moving components
of the motorcycle (e.g., transmission) or with the rider
(e.g. the boot area).
E. SYMBOLS
We declare that this supplied product is compliant with
RoHS Directive 2011/65/EU amended by the Directive
2015/863/EU (RoHS3) relative to the Restriction of
the Use of Certain Hazardous Substances.
GET Map
MAP
SWITCH
7
CDI
EN