Notes On Maintenance; Important Notes; Repairs - Rehau RAUTOOL X-PRESS1 Manual De Instrucciones

IMPORTANT NOTES

Notes on maintenance

Regular inspection:
Danger of injury!
Always pull mains plug or remove battery before cleaning
and inspection work
- Always keep jaw sets and cylinders clean. When contaminated, clean them
using a brush and lubricate with oil. Afterwards store the tool on a dry place.
- Before use, check the clamping geometry of the push-in jaws for damage or
visible wear. Damaged tools must no longer be used and must immediately
be sent to an authorized REHAU service center for repair.
- Slightly lubricate the pin joint, the driving rolls and its guide.
- Make sure that the push-in jaws close completely during clamping.

Repairs

Risk of accident!
Do not carry out any tool repairs yourself Repairs must only be
carried out by an authorized service center
Compulsory inspection and maintenance interval for basic tool and
push-in jaw
According to test badge or after 5,000 clamping operations, -
LED display on the tool
- (depending on what occurs first) Correct clamping joints require a functional
and periodically maintained clamping tool.
- Compulsory checking of the push-in jaw or tool in an authorized REHAU
service center.
The compulsory due date for an inspection is evident from the test badge on
the basic tool and the push-in jaws, e.g. May/2015
If this service interval is not observed, the warranty claim is omitted.
Figure similar
24
All manuals and user guides at all-guides.com
RAUBASIC
RAUBASIC
RAUBASIC
RAUBASIC
Compatibility
Caution!
Danger of material damage!
Inexpert handling of the RAUTOOL X-press1 may result in leaking joints
The RAUBASIC push-in jaws are not compatible with the RAUMULTI
fitting!
- BASIC push-in jaws must exclulsively be used in conjunction with the
RAUBASIC fitting (not fixed compression sleeve).
RAUBASIC
RAUBASIC
RAUBASIC
RAUBASIC
RAUMULTI
RAUMULTI
RAUMULTI
RAUMULTI