Charging The Battery - Simon, Evers & Co K 522 823 Instrucciones De Manejo Y Mantenimiento

II. CAUTION
1. Prolonged continuous working might cause dmage of the power pack.
2. Stop operation if temperature of hydraulic oil is too high.
The lifter is not water proof and is intended to be used in a dry environment.
3. Do not place the lifter on an inclined surface as it may become not controllable
and cause a risk.
4. Do not use Lifter with unstable, unbalanced or loosely stacked load.
III. OPERATING LIFT TABLE
Caution
Brake lift table when not moving it in order to prevent sudden movement.
The brake is equipped with the swivel caster on the right side.
1. Brake the wheel press, the brake pedal.
2. Releasing the brake, lift up the brake pedal.
IV.

CHARGING THE BATTERY

Connect the charging port of battery socket to the battery charger.
If the unit is not in operation, the battery must be charged at least every 3 months.
V. Inspection and maintenance instructions
Safety warning
Before inspection and maintenance work is carried out, appropriate measures
should be taken to remove all loads from the electric lift table.
Inspection and Maintenance
Check operating elements for faultless operation
Check condition of the travelling rollers and roller axles
Check functioning of wheels and rollers
Is the top lifting height reached effortlessly?
Check all parts of the lifting table for wear and replace
defective parts where necessary
Authorise inspection by competent technical expert
The service life of your lift table is limited. Worn parts
must be renewed in adequate time.
Inspection interval
Daily or before
operation
Monthly
Every 3 months
Yearly