Danby Silhouette Professional DIM32D1BSSPR Manual Del Propietário página 10

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Open the door to a 90° angle and remove two
screws from the door axis.
2. Slide the bottom of the door outward to remove
it from the cabinet.
3. Remove three screws from the top right hinge
and remove the right top hinge.
4. Remove the screw hole covers from the top left
of the cabinet and install the top left hinge at the
top left of the cabinet with three screws. Block
the holes at the top right of the cabinet with the
screw hole covers.
5. The lower left hinge is pre-installed on the
cabinet.
6. When reinstalling the door, it will need to be
fl ipped 180° from its original position to ensure
that the handle is on the correct side. Install the
door by sliding it onto the top hinge pin.
7. Replace the door axis by placing the hinge pin
in the bottom of the door and securing it to the
bottom left hinge with two screws. Ensure the top
of the door is properly aligned with the top of
the cabinet and that the rubber gasket makes a
good seal with the cabinet all the way around.
A. Bottom Right Hinge
B. Door Axis Screws
C. Door Axis
D. Top Right Hinge
E. Hinge Screws
F. Top Left Hinge
G. Screw Hole Cover
H. Bottom Left Hinge
1
A
2
3
4
F
5
H
6
7
9
C
B
D
D
E
G
F
H
C B