Service Information - Stanley STEL701 Manual De Instrucciones

Trozadora de metal

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

22 • ENGLISH

LUBRICATION

STANLEY power tools are properly lubricated at the

factory and are ready for use. Tools should be

re-lubricated regularly , depending on usage. This

lubrication should only be attempted by trained power tool

repair persons, such as those at STANLEY service

centers or by other qualified service personnel. Closed-

type, grease-sealed ball bearings are used throughout.

These bearings have sufficient lubrication packed in them

at the factory to last the life of the chop saw.

CLEANING

Warning! unplug the tool before you use a cloth to

clean the housing.With the motor running, blow dirt and

dust out of all air vents with dry air at least once a week.

Wear safety glasses when performing this. Exterior plastic

parts may be cleaned with a damp cloth and mild

detergent. Although these parts are highly solvent

resistant, NEVER use solvents. Blowing dust and grit

out of the main housing by means of an air hose is

recommended and may be done as often as dirt is seen

collecting in and around the air vents. Always wear proper

eye and respiratory protection.

TOOL CARE

Avoid overloading the machine.Overloading will result in a

considerable reduction in speed and efficiency and the

unit will become hot. In this event,run the machine at no

load for a minute or two until cooled to normal working

temperature by the built in fan. Switching your machine on

and off whilst under load will considerably reduce the life

of the switch.

IMPORTANT

To ensure product Safety and Reliability, repairs,

maintenance and adjustment (other than those listed in

this manual) should be performed by authorized service

centers or other qualified organizations, always-using

identical replacement parts. Unit contains no user

serviceable parts inside. Blowing dust and grit out of the

main housing by means of an air hose is recommended

and may be done as often as dirt is seen collecting in

and around the air vents. Always wear proper eye and

respiratory protection.

Note: Unit may be converted to a 3-wire twist lock cord set

at an authorized service center.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be

disposed of with normal household waste.

Should you find one day that your STANLEY

product needs replacement, or if it is of no

further use to you, do not dispose of it with

household waste. Make this product available for

separate collection.

Separate collection of used products and

packaging allows materials to be recycled and

used again. Re-use of recycled materials helps

prevent environmental pollution and reduces the

demand for raw materials. Local regulations may

provide for separate collection of electrical

products from the household, at municipal waste

sites or by the retailer when you purchase a new

product.