Publicidad
Idiomas disponibles
Idiomas disponibles
support@nextlevelracing.com
29
Align the slots on the bottom Shifter Mounting Corner Bracket with the T-Nuts previously installed in
STEP 28. Bolt through and secure with 2 x M8 Bolts and Washers.
30
Align the slots on the upper Shifter Mounting Corner Bracket with the T-Nuts previously installed in STEP 28. Bolt through and
secure with 2x M8 Bolts and Washers. Leave Bolts loosely tightened to allow installation of extra parts in the following steps.
OUTSIDE VIEW
31a
Install 4 x T-Nuts into the top and bottom side channels of the Shifter Arm.
PARTS:
• • 1 x Shifter Mounting Corner
Brackets
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
PARTS:
• • 1 x Shifter Mounting Corner
Brackets
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
PARTS:
• • 1 x Shifter Arm
• • 4 x T-Nuts
24
31b
Install 2 x T-Nuts into the top channel and 2 x T-Nuts into the bottom channel of the Shifter Arm.
INSIDE VIEW
OUTSIDE VIEW
31c
Install 2 x T-Nuts into the top inner channel of the Shifter Arm.
32
Align the T-Nuts previously installed into the Shifter Arm in STEP 31b with the holes on the upper Shifter Arm Bracket previously
installed in STEP 30. Bolt through and secure using M8 Bolts and Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 4 x T-Nuts
PARTS:
• • 2 x T-Nuts
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
Note: The outside of the Shifter Arm should
always have 4 x T-Nuts installed to allow
installation of the Tool Kit Holder.
25
25
Publicidad
