Heylo HL 400 Manual De Instrucciones página 17

WIFI
Display:
Press the "Child Lock" button to activate the child
"Child Lock" button for 5 seconds to cancel the function
NOTE: To display the filter run time, press and hold the "Child Lock"
(before entering an operating mode) to see that the filter has been used
between 0- 1500 hours. After displaying for 5 seconds, it will
automatically exit the display.
When the product is switched on, pressing the "AUTO" button activates
negative ion generator and the UV lamp and the working level is set
depending on the sensor data. (The symbol lights up while the product
operating in automatic
changes the blower speed while the
automatically terminated.
Fan stage PM2.5 value
1 less than 120
2 121-250
3 251-500
Light sensor:
In automatic mode, the product is put into sleep mode when the ambient
light falls below the value <5×. It exits the sleep mode again, after the
ambient light exceeds <5× for 3 minutes and then returns automatic mode.
For the operation of the WIFI function,
please refer to the WIFI quick start guide
included with the device
This product comes with a remote control
powered by 3V lithium cells. (Please
remove the cells when not using the
remote control for a long period of time).
The controls on the user interface on the
unit and on the remote control are directly
similar: all functions and operating modes
are basically identical.
Filter display
Light sensor
Air quality display
mode and disappears
automatic
Fan speed
430
600
900
17
lock. Press and hold the
otherwise). If the user
mode is active, this mode is
Display colour
green
orange
red
CURRENT SUPPLY
ON / OFF
EN
the
i
s