Athena GET WIFI-COM HONDA Guia página 4

2.
Find the OEM diagnostic
four-pole connectors situated
in the front left side of the bike: if
necessary, check the workshop
manual to find the connectors.
Remove the OEM red cap.
3.
Connect the female
connector of WiFi-
COM Honda to the male
connector of the motorcycle.
Cover the male WiFi-COM
HONDA connector with the
OEM red cap.
ATTENTION:
- Always make sure that the connectors are correctly
associated; when connecting them, a "click" is heard
that indicates they are connected correctly.
- If you want to keep the WiFi-COM HONDA
installed on the bike, fix it in a well-protected point
on the motorcycle. We suggest installing it on the
top of the front fork and fastening it with zip ties.
Keep the WiFi-COM HONDA away from spark plug
cables, coils, and sources of excessive heat.
- After the installation, check that the wiring does
not obstacle the free movement of the handlebar
in both directions nor interferes with the moving
components of the motorcycle (e.g., transmission)
or with the rider (e.g., the boot area).
EN
CAP
GET
OEM WiFi-COM HONDA
CAP
6
4.
Re-install the left
radiator shroud. On Honda
CRF 250 / 450 L and RL
replace the seat.
D. OPERATION OF GET WIFI-COM HONDA
1.
Download the free WiGET app on your phone or tablet
from the App Store or Google Play.
WiGET App
7 EN