Charging The Battery; Inserting The Battery; Removing The Battery - Hilti R 6-22 Manual Del Usuario

Storage temperature
Battery charging starting temperature
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 4
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release button.
2. Remove the battery from the product.
5.4 Inserting the back-up batteries
It is not possible to save settings unless the batteries are correctly installed.
Make sure that battery polarity is correct.
1. Remove the cover from the battery compartment.
2. Insert the 2 AAA batteries supplied with the appliance into the battery compartment.
3. Install the cover on the battery compartment.
5.5 Switching the appliance on / off
▶ Press the Power button.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Establishing a Bluetooth connection
If you are prompted for a code, enter the code 0000.
*2309425*
2
3
4
2309425
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
English 7