Fm Radio Operation - Roadstar HRA-250IP/WH Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23

FM RADIO OPERATION

Operation
Press the POWER Button on the unit (10) or the remote control (1) to turn the unit on.
Select the RADIO function with the SOURCE Button on the unit (4) or on the remote control
(9).
There are a number of ways that you can tune to radio stations. Follow the instructions
in the sections below.
Adjust the VOLUME to the desired level using the VOLUME -/+ buttons (11,15) or the
VOLUME -/+ Buttons (8,17) on the remote control .
To turn off the radio, press the POWER Button again.
Manual Tuning
Manual tuning is useful when you already know the frequency of the desired transmitter.
To change the frequency, repeatedly press the
main unit until the precise frequency is reached.
From the remote control, press the
reached.
Automatic Tuning
Press and hold the
TUNE/CLK+ or
radio will start automatically scanning for strong radio signals. The RADIO Display shows
the frequency in MHz for Fm.
The tuner will stop scanning when it finds a strong signal.
Repeat this process until the desired station is found.
Notes: As automatic tuning depends on the signal strength of the transmitters, weak
transmitters are sometimes skipped. In such a case, tune manually to find the
weaker transmitters.
On the other hand, with a very strong signal, the tuner may stop before it reaches
the optimum setting. Tune manually for the best reception.
Storing Stations (from Remote Control only)
English
TUNE/CLK+ or
TUNE/CLK- from
or
button until the precise frequency is
TUNE/CLK- Buttons for about 5 second. The
7
8
English
This unit allows you to store the frequencies of up to 20 radio stations in the memory;
First tune into the station you want to store using one of the methods above.
Then press the Preset button on the remote control (11).
Press playlist Buttons the remote control (3) to select the desired channel memory and
press the Preset Menu button (11) within 5 seconds to store it.
To reprogram a preset station repeat the procedure above.
Selecting a preset station
To select a preset station, press the Jog/Mode button and turn the Volume/Tune knob on main
unit or press the Playlist-UP
the desired preset program is displayed.
FM Antenna
For FM reception there is a wire antenna (17) at the rear of the unit. Extend it for best reception.
iPod iPhone OPERATION
1.
Insert the iPod player in the iPod deck bracket on the top of the main unit fixedly.
2.
Power on the main unit, and then press the SOURCE button to the iPod mode, the
iPod indicator will appear on the display of the main unit.
With unit in iPod mode:
1.
Press the PLAY/PAUSE
Adjust the volume control by tthe VOLUME buttons. To stop the current
playing, press the PLAY/PAUSE button once.
2.
Press the PLAY/PAUSE button once to pause the current track. To resume the
playback, press the PLAY/PAUSE button once again.
3.
To skip forwards or backwards, press the TUNE/CLK+ or TUNE/CLK- button to
select the desired track.
Charging the iPod Player battery through the main unit:
1.
The iPod Player has a internal non removable battery, the battery may need to be
charged when it is not used for a while.
2.
You can charge the iPod Player through the main unit automatically under the
STANDBY or POWER ON mode.
or Playlist-DN
Buttons on the remote control (3,4) until
button once to start the iPod playing.

Publicidad

Tabla de contenido
loading

Tabla de contenido