Alarm Setting; Snooze Function - Roadstar HRA-250IP/WH Manual De Instrucciones

2. Press the TUNE/CLK+ or TUNE/CLK- button (16,14) to adjust the hour digit.
3. Press the TIME SET button (5), the HOUR digit will flash on the display,
press the TUNE/CLK+ or TUNE/CLK- button (16,14) button to adjust MINUTE digit.
4. Press the PLAY/PAUSE/FM button once more, the MINUTE digit will flash on the display,
press the TUNE/CLK+ or TUNE/CLK- button (16,14) button to adjust MINUTE digit.
5. Press the PLAY/PAUSE/FM button again to confirm the time.
6. Each state as shown above will be cleared if the key is not pushed in10 seconds.

ALARM SETTING

This unit provides two alarms setting that work independently from each other, thus allowing
you to customize each one to your preference. You can set the alarm and the source of the
alarm.
During in the STAND-BY OFF/ON mode.
1. After adjusting clock, press the ALARM SET button on the unit (13) and "
" " appears on the display.
2. Press the ALARM SET button again on the unit (20) for a few seconds, and the display
digit of the HOUR flashes.
2. Press the TUNE/CLK+ or TUNE/CLK- button (16,14) to adjust it.
3. Press the ALARM SET button again, the MINUTE digit will start flashing, adjust it by
pressing the TUNE/CLK+ or TUNE/CLK- button.
4. Press the ALARM SET button once more to confirm and order ALARM time.
5. After adjusting "TIMER -ON", the ALARM VOLUME LEVEL,
Adjust it by pressing the TUNE/CLK+ or TUNE/CLK- button.
When the Alarm Clock activates, the Volume will gradually increase from 0 to the volume
level you set.
6. Press the Alarm Set again and you can select the wake up mode from
English 5
" or
"20" appears on the display.
iPOD,
6 English
AUDIO or BEEP.
8. Each enable state as shown above will be cleared if the button is not pushed in 7 seconds.
ACTIVATING THE ALARM WAKE UP MODE
1. Press repeatedly the ALARM SET button to activate the alarm function and select the wake-
up mode.
2. The alarm mode and corresponding icon RADIO / IPOD / BEEP appear in sequence to the
display.
NOTE: If Alarm wake-up with iPod mode, need to put the iPod in the docking station.
To wake up with RADIO, make sure that the FM Antenna is extended properly and select a
preset station or tune the Radio to your preferred FM station.
To switch OFF the Alarm, press any button in the unit or remote control.

SNOOZE FUNCTION

During the alarm, press the SNOOZE/DIMMER button from unit or remote control will
temporary switch OFF the alarm for 9 minutes and the snooze icon will be displayed. This
is repeatable in the hour alarm duration.
BASS & TREBLE CONTROLS (FROM REMOTE CONTROL)
It is possible to modify the BASS and TREBLE sound tone.
When you press the Bass or Treble button, the sound tone can be changed.
SLEEP FUNCTION (BY REMOTE CONTROL)
1. If you want to fall asleep to music, press the SLEEP button on Remote Control.
2. You may select the TUNER, iPod or AUX mode in sleep function to play from 15, 30, 45
or 60 minutes of music before shutting itself off automatically.
FUNCTION SELECT
1. Press repeatedly the FUNCTION button (4) on the unit or on the remote control (9) to select
the desired. Display changes as: iPod - RADIO - AUX-IN.