Equipment Identification - IARP STOK Serie Instrucciones De Uso Para El Usuario

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante

10. EQUIPMENT IDENTIFICATION

• Located on the plate affixed to the machine to detect the technical data.
• Check the model and power supply voltage before carrying out any operation.
• If discrepancies are found, immediately contact the manufacturer or the company that supplied the equipment.
Please refer to the information indicated on the product. You will find the information on the rating label on the
back of the unit as well as inside the cooling compartment.
The circuit diagram is displayed on the back of the unit as well as inside the cooling compartment.
It is strictly forbidden to remove, tamper with the plate and change or alter the data
contained in it.
11. TURN ON
1. Close the door of the appliance.
2. Ensure the power switch is set to [O] then connect to the power outlet.
3. Switch on the Power [I]. The current temperature within the appliance is displayed.
*
4. The on the control panel will flash to indicate a delay to compressor start.
12. MESSA IN SERVIZIO
If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12
hours before operation. Failure to do so can cause total destruction of the compressor refrigerating system.
If power is cut off, wait for at least 3 minutes before restarting the appliance to avoid damaging the compressor.
The key to the electrical cabinet should be kept out of the reach of children and users.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE TO BE CONNECTED
IS TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL SWITCH
(Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO THE GENERAL
EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple socket
outlets to connect the counter. DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on,
away from water and the other liquids and heat sources and must not be damaged. In case of breakage of the power cable of the
cabinet, it must be replaced by the manufacturer or by instruction it change of it.
If the cable does not reach the nearest socket, either rearrange your store layout or ask a qualified electrician
to fix a new socket.
This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must
be inserted into an outlet that is properly grounded and installed. Consult a qualified electrician or
service center if you do not completely understand the grounding instructions. If doubt exits whether
the appliance is properly grounded, have a qualified electrician check the circuit to make sure the
outlet is properly grounded.
ATTENTION!
Correctly connect and disconnect the plug. When inserting ensure the plug is fully engaged.
While unplugging hold the body of the plug. Never pull the supply cord directly.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with the electrical regulations for
the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.
STOK
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
1 8 / 6 0
PAGE
N° DOC