Headrest Adjustments; Removing Axkid Minikid 3 Car Seat From The Vehicle - Axkid Minikid 3 Manual De Instrucciones

Headrest Adjustment
The Axkid Minikid 3 is equipped with an automatic headrest (A) that will ensure the headrest (A) always is in the best position for your
child. When the harness is being tightened, the headrest (A) will lower itself to the correct height and automatically lock in position. When
loosening the harness, the headrest (A) will move back up to its top position again and unlock. To ensure the best fit, Axkid recommends
using this feature every time you restrain your child.
The headrest (A) only unlocks in its top position. It is therefore important to ensure that the headrest (A) moves all the way to the top
position when loosening the harness, otherwise the headrest (A) will stay locked and will not move down when tensioning the harness.
If you want to deactivate the automatic adjustment feature and keep the headrest (A) in a fixed position, place the headrest (A) in the
desired position and switch the headrest brake lever (H) to the locked position. The headrest (A) is now locked in height and will not move
until you switch back the headrest brake lever (H) to the unlocked position again.
When using your Axkid Minikid 3 with the headrest (A) in a fixed position, ensure the headrest (A) is positioned in the correct height for your child.
Check that the shoulder straps (R) are going through the seat straight from your child' s shoulders or maximum 1 cm above. If not, adjust the head-
rest (A) by switching the headrest brake lever (H) to unlocked position and push the headrest (A) to the top position to unlock it and then repeat the
procedure.
Removing Axkid Minikid 3 car seat
from your vehicle
• Unzip the zipper and open the belt clamp lid (O). Unlock the vehicle seat belt by pressing the red button on the seat belt buckle. Open the
belt clamp (N) and pull the vehicle seat belt and guide it through the seat belt slots (D) to remove it from the car seat
• Unlock the lower tethers (M) by holding on to the connectors with your hand and pressing on the red button with your thumb. While keeping
the connector in your hand, slowly feed it back to the car seat. Be careful not to let go of the lower tether connector, as it will retract back
automatically with high speed.
• Push the support leg button (Q) and collapse the support leg (P) to its shortest position.
• Press the recline adjustment lever (G) and push in the recline angle adjuster (T) to its shortest position. Lift the Axkid Minikid 3 out of the
vehicle.
Tip: Lock the harness buckle and tension the harness before removing the car seat from the vehicle. You can then use the shoulder straps (R) as a
carrying handle, making it easier to lift out the car seat and transporting it outside of the vehicle.
Important: Never carry the car seat by holding in the headrest (A)
Recycling your car seat
Axkid strongly recommends recycling of old car seats. Before leaving the seat at your local recycling station
cut off the harness straps from the seat, remove the textile cover, remove as many Styrofoam parts as possible,
separate metal and plastic parts if possible. The main part of the seat should be marked unsafe or expired
(use a marker) to deter anyone from using it again. Please check your local municipal guidelines for recycling
instructions for the different materials.
20