Spypoint CELL-LINK Guia De Inicio Rapido página 12

INSTALLING AND CONNECTING THE CELL-LINK
To connect the SPYPOINT CELL-LINK to your trail camera
from any brand, follow these steps.
We recommend that you watch our video which will guide
you through the different installation steps. Go to
www.spypoint.com/en/support.
1. Open your camera door.
2. Take the cable with SD adapter and
insert the SD card extemity (#CL-CBL)
in the corresponding slot.
3. Pull the cable with SD adapter down
and hold it against the camera. We
suggest that you make at least one
loop with the cable and place it inside
the camera housing. This way, the SD
card will not be disconnected if the
cable is pulled (when you close the
camera door, for example). The cable
should therefore hang freely on the
outside of the camera. Important:
Avoid running the cable in front of the
lenses or other essential components.
4. Shut the camera door and lock the
latch.
12