Tabla de contenido
Publicidad
Step 21
Fasten the TOP (A) to the END FRAMES (K and L). Turn
å
six 1/2" HEX HEAD SCREWS (15) using the L-WRENCH (9).
Fasten the LARGE TOP MOLDING (H) to the TOP FRONT
å
BRACE (O). Tighten two 1" HEX HEAD SCREWS (13) using
the L-WRENCH (9).
NOTE: You should start each SCREW a few turns
å
before completely tightening any of them.
Now, completely tighten all of the SCREWS in
å
your unit.
1/2" HEX HEAD SCREW
(6 used in this step)
Page 26
15
9
K
429405
OPENING ON THE RIGHT
A
L
H
O
13
1" HEX HEAD SCREW
(2 used in this step)
whiskersupport.com
Publicidad
Tabla de contenido
