Cut-Out Template; Installation - dali PHANTOM H Serie Manual De Instrucciones

4.2 Grille
The metal grille is attached by means of magnets incorporated in the top of the
speaker. Carefully place the grille so that it covers the top of the speaker, and the
magnets will secure it.
NOTE: On the inside of the grille there is a piece of non-woven. The non-woven is
on the grille to protect the drivers against dust and dirt. Therefore the non-woven
must remain on the grille.
The supplied DALI logo badge can optionally be mounted on the grille. To mount the
logo badge, remove the protective film from the rear side of the logo badge and
position the logo on the grille in the desired position (see figure 5).
4.3 Connection of Cables/Selection of Cables
Your choice of cables is a crucial element in your installation. Be aware that replacing
cables after installation is a difficult task. Therefore, select quality cables from the
beginning. Please consult your authorized DALI dealer for further advice on which
cable to select.
When connecting the cable to the loudspeaker and the amplifier, it is important that
the loudspeaker is connected in correct phase. The red (+) loudspeaker terminal
must be connected to the red (+) amplifier terminal. The black (-) loudspeaker
terminal must be connected to the black (-) amplifier terminal. If the loudspeakers
are not connected in correct phase, the soundstage will typically be diffuse and the
bass will be weak.
To insert the cable end into the spring loaded terminals of the speaker, remove
cable insulation so that approx. ½" / 12 mm of bare wire is exposed. Press the top of
the terminal down and insert the bare wire into the opening. When the wire is fully in
place with no loose strands exposed, release the terminal (see figure 6).
5 . 0 C U T - O U T T E M P L AT E
The enclosed cut-out template (see figure 7) can be used to initially visualize how
your speakers should be mounted and for marking where the cut-out should be
made. Tape the template at the preferred mounting position, so that you can mark
the necessary opening. The minimum mounting depth for the DALI PHANTOM H-50,
H-60, H-60 R and H-80 R is 95 mm / 3.7", for the DALI PHANTOM H-80 it is 106
mm / 4.2" and for the DALI PHANTOM H-120 it is 168 mm / 6.7".
6 . 0 I N S TA L L AT I O N
Please study and follow the safety guidelines found in chapter 2.0 of this manual! The
DALI PHANTOM H Series must be installed by a trained professional to ensure
that all safety requirements are met and to prevent the speaker from falling.
NOTE: Earth Quake Safety Hook:
DALI PHANTOM H Series is equipped with an earth quake safety hook. To prevent
injury or damage from a fall, a non-elastic steel wire should be attached safely by
10