Beacon Lighting LUCCI PFC56-3B-ABS-US Serie Instrucciones De Instalación página 12

Airfusion Whitehaven Installation Instructions
Remote Control Buttons (
1 - FAN SPEED CONTROL BUTTON:
There are 6 available speeds. "I" button is for the lowest speed, and "VI" button is for
the fastest speed.
NOTE: when you turn on the fan for the first time or switch the main power to the
controller, you need to start the fan on high "VI" speed first and then choose a lower
speed. A 5-10 seconds is required to allow the DC fan to respond to the remote each
speed or fan direction selections.
2 - FAN OFF BUTTON:
Press the button to turn the fan off.
3 - REVERSE FUNCTION BUTTON:
Press the button to activate the reverse running function. The fan must be operating
to activate the reverse function.
4 - LIGHT CONTROL BUTTON:
Press the button to turn the light ON/OFF.
The LED light has a 3-step dimmable function which is controlled by an ON/OFF switch.
When the LED light is ON and at 100% brightness, press the light button "ON and then OFF within 5
seconds", to dim the LED light. Repeat pressing ON and then OFF within 5 seconds to dim further in the
following sequence: 100% brightness → 40% brightness → 15% brightness → 100% brightness.
To switch back to 100% brightness at any stage, turn OFF the luminaire, and then wait after 5 seconds turn
ON the luminaire, it will reset to 100% brightness.
REPAIRING THE REMOTE & RECEIVER PAIRING – WHEN 1 CEILING FAN IS INSTALLED
•
If the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired.
•
Below are the operating symptoms and the steps to repair the pairing of the remote and receiver.
Symptoms:
•
Loss of control - Fan is only running at high speed after installation
•
Loss of control - No reverse function after installation
•
Loss of control - Remote cannot communicate with receiver
Repairing Steps:
A. Switch OFF the main power to ceiling fan for 30 seconds.
B. Press and hold the "
ON to the receiver of the ceiling fan.
Turn ON and change the speed of the ceiling fan via the remote to check the operation and successful
C.
paring.
11 | P a g e
Fig. 16)
" button on the remote for 3-5 seconds within 30 seconds of switching the power
Fig. 16