Mega Cocina MCVSBL Manual De Instrucciones página 13

3. After filling the Glass Jar with ingredients, secure the Plastic Lid with
Feeding Hole into position. Plug the product into a standard 120-volt AC
electrical outlet.
4. Push the desired blender speed button.
CAUTION: NEVER operate the product's motor for more than a few minutes
at a time. Select and depress a blender speed button, allow the motor to cool
for a few seconds; then press the blender speed button again until you achieve
the desired results.
5. To turn off the product, press the "OFF" Button.
6. Unplug the product from the electrical outlet when finished blending
ingredients, when the product is not in use, or if leaving it unattended.
CAUTION: DO NOT use the product for blending heavy foods or thick
mixtures.
NOTE: The "PULSE" Button can be used for more control during short
processing jobs to run the blender motor at a high speed. When finished
processing ingredients with the "PULSE" Button feature, release the "PULSE"
Button to turn the Pulse function off.
Cleaning and Maintenance
WARNING: ALWAYS unplug the product from the electrical outlet before
assembling, disassembling, or cleaning it.
• If the product's motor does not run freely while blending ingredients, perform
one or more of the following steps, as necessary:
o Press the "OFF" Button and add water to the ingredients
o Press the "PULSE" Button for a few minutes to see if the motor will blend
more freely
o Press the "OFF" Button, unplug the blender from the electrical outlet, and
use a rubber spatula to clear the sides of the Glass Jar and push the
ingredients toward the Blades
o Reduce the amount of ingredients inside of the Glass Jar
• Clean the product immediately after each use. Before cleaning, remove the
Glass Jar from the Motor Housing and the Plastic Lid, Blades and Spin Base
from the Glass Jar.
• Use a small toothbrush (not included) to remove particles of food lodged
underneath the Blades.
• Clean the exterior surface of the Motor Housing by wiping it with a soft, damp
cloth.
• DO NOT use abrasive cleaners or scouring pads to clean the product.
• To clean the Glass Jar, add ¼ teaspoon of liquid soap to the Glass Jar and
fill with warm water. Place the Glass Jar on the Motor Housing and press the
"PULSE" Button several times for a few seconds. Remove the Glass Jar from
the Motor Housing and rinse the Glass Jar underneath running water.
CAUTION: DO NOT place the Glass Jar and the Plastic Lid into a dish
washer or in extremely hot water.
• Dry ALL product parts thoroughly before storing.
• Store the product in a clean, dry place with the Plastic Lid removed from the
Glass Jar.
6