Tabla De Contenido; Parts And Functions - Phottix Mitros+ Manual De Instrucciones

Ocultar thumbs Ver también para Mitros+:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
Transceiver Flash for Sony
Note: To start immediately using this flash please refer to the Quick-Start guide.
For advanced features please read this manual and be familiar with your camera
manual and operations.
The Phottix Mitros+ TTL Transceiver Flash for Sony is designed to work with
Sony DSLR cameras and features TTL, Manual, Multi modes as well as Wireless
Master/Slave triggering.
Warnings
1. Use your flash safely. Do not fire the flash into the eyes of people or animals at
short distances - it could cause damage and/or blindness.
2. Be careful using the flash in or around cars, buses, motorcycles or other mov-
ing vehicles as accidents can result.
3. Never use the flash near combustible gases (gasoline, solvents, etc.).
4. Do not expose the flash or batteries to dripping/splashing water, or high hu-
midity.
5. Do not leave the flash or batteries in a hot location (direct sunlight, in a closed
car, etc.).
6. Remove batteries from the flash when not being used for an extended period
of time.
7. Change the batteries when required. Use undamaged batteries in good con-
dition. Do not mix battery types or new and used batteries.
8. Do not put opaque objects in front of the flash lens when firing the flash. The
energy emitted by the flash may cause objects to burn, or cause damage to the
flash tube or fresnel lens.
9. Use caution in touching the flash head after use. It may be hot and could
cause burns.
10. The flash contains high voltage electronic parts. Do not disassemble or at-
tempt to repair the flash. Never touch the flash's internal components.
11. Do not touch the External Power Port. Ensure it never comes into contact
with metal objects - this can cause electric shock and serious injury.
12. Keep out of the reach of children.
13. Please observe the safety and operating precautions and consult local au-
thorities on the proper disposal or recycling of a Phottix Mitros+ TTL Transceiver
Flash.
Table of Contents
Parts and Functions ................................................................... 2
Modes ......................................................................................... 7
Wireless Triggering....................................................................10
Custom Functions......................................................................14
Technical Specs..........................................................................16
2
Phottix Mitros+ TTL
INSTRUCTION MANUAL
En
Parts
Back / Left Side
1. LCD Display
2. Mode Button
3. Test Button
4. Power Switch
5. Ready Light
6. Arrow Adjustment Buttons
(see below)
7. Set Button
8. Locking Lever
9. 3.5mm Sync Port
10. USB Port
11. External Power Port
Arrow Adjustment Buttons
1. Up Arrow / Zoom Adjustment Mode Button
2. Right Arrow / Wireless Flash Mode Button
3. Down Arrow / HSS Button
4. Left Button / Custom Functions Button
Front / Right Side
1. Bounce Card
2. Wide Angle Diffuser
3. Flash Head
4. Wireless Signal Receiver Area
5. AF Assist Light
6. Hot Shoe
7. Battery Compartment

Publicidad

Tabla de contenido
loading

Tabla de contenido