Kobalt 0019002 Manual Del Usuario página 8

ASSEMBLY INSTRUCTIONS
5. Mount the two fixed casters (K) to the
base panel (E) using M8 x 25 mm bolts
(BB), M8 mm spring washers (CC) and
M8 mm flat washers (DD). Repeat this
process for the swivel casters with
brake (L) on the opposite side of the
base panel (E). Lock the swivel casters
with brake (L) before you proceed to
the step 6. Place the cabinet upright.
Note: The swivel casters with brake (L) must
be installed in the front of the cabinet. Be sure
to lock both casters to prevent cabinet from
rolling or swiveling. Do not over tighten the
screws.
Hardware Used
M8 x 25 mm
BB
Bolt
M8 mm Spring
CC
washer
6. Install the bottom shelf (G) by tipping it to
the side and inserting it into the cabinet.
With bottom shelf (G) at an angle, align
the cut-outs on the bottom shelf (G) with
the back seams caused by side panels (C
and D) and back panels (A and B).
Carefully lower the bottom shelf (G),
ensuring the front of the bottom shelf (G)
goes over the front flange of the base
panel (E).
Determine the location for the adjustable
shelf (H). Hold the adjustable shelf (H) at
an angle to make it easier to install.
Please make sure adjustable shelf (H)
snaps into the hooks on the unit.
Note: If the hooks are flatted during
assembly, use a slotted screwdriver (not
included) to recover them.
5
L
E
K
CC
BB
x 16
DD
x 16
6
H
C
E
8
E
DD
M8 mm Flat
washer
G
D
K
x 16
C
H
A