Care And Maintenance; Memory Function; Setting The Child Lock - Danby DDMW1125BBS Manual Del Propietário

OPERATING INSTRUCTIONS

MEMORY FUNCTION

The memory function allows the programming of
cooking times and powers that can be recalled and
used again and again with minimal input. Three
memory programs can be set at one time, they are
labeled 1, 2 and 3.
To set Memory 1:
1. Press the 0/Memory button once. The number 1
will display.
2. Press the Time Cook button and then use the
number pad to enter the desired cook time.
3. Press the Power button once. The power level
will default to 100%. "PL10" will display. To
change the power level, use the number pad to
enter the desired power level.
4. Press the Start/+30SEC button to save the
setting.
5. To use the setting in future, press the 0/
Memory button once and when the number 1
is displayed, press the Start/+30SEC button to
begin operation.
To set Memory 2 or 3, press the Memory button two
or three times until the number 2 or 3 are displayed
and then follow the steps above.
Note: If the power is lost or the appliance is
unplugged, the memory settings will need to be
reprogrammed.

SETTING THE CHILD LOCK

To set the child lock press and hold the Stop button
for 3 seconds. The appliance will beep to indicate
that the child lock is activated. While locked, the
appliance cannot be used.
To cancel the child lock, press and hold the Stop
button for 3 seconds. The appliance will beep to
indicate that the child lock has been deactivated.

CARE AND MAINTENANCE

CLEANING
Turn off and unplug the appliance before
performing any cleaning.
The inside of the appliance should be cleaned with
a warm, damp cloth and mild detergents. Do not
allow food splatters to build up on the inside of the
appliance as this can affect the effi ciency of the
microwave and if suffi ciently dirty, can ignite and
cause fi re.
The outside of the appliance should be cleaned with
a warm, damp cloth. To avoid damage to internal
components, do not allow any water to drip into the
ventilation openings.
Clean the door and window on both sides, the door
seals and the adjacent parts frequently with a damp
cloth to remove any spills or splatters. Do not use
abrasive cleaners.
Do not allow the control panel to become wet. If
necessary, clean the control panel with a damp
cloth and then wipe dry.
The glass tray can be removed and cleaned in
warm water and mild detergent or can be placed in
a dishwasher.
The roller ring and oven fl oor should be cleaned
regularly to avoid excessive noise or spilling. The
roller ring can be cleaned in warm water and mild
detergent or can be placed in a dishwasher. Ensure
that the roller ring and glass tray are replaced in the
proper position to avoid noise or spilling.
MAINTENANCE
To remove odors from the microwave:
1. Combine a cup of water with the juice and skin
of one lemon in a microwavable bowl.
2. Microwave on full power for 5 minutes.
3. Wipe the inside of the appliance and glass tray
and roller ring thoroughly with a warm, damp
cloth.
12