Descargar Imprimir esta página

Poulan Pro 331 Manual De Instrucciones página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

BEFORE
STARTING
ENGINE
_WARNING:
Be sure to read the fuel
information in the safety rules before you be-
gin. If you do not understand the safety rules,
do not attempt to fuel your
unit. Call
1-800_554-6723.
FUELING
ENGINE
_WARNING:
Remove fuel cap slowly
when refueling.
This engine is certified to operate on um
leaded gasoline. Befc_e operation, gasoline
must be mixed with a good quality synthetic
2*cycle air-cooled engine oil designed to be
mixed at a ratio of 40:1. PoulanANeedEater
brand synthetic oil is recommended. Mix gasc_
line and oil at a ratio of 40:1. A 40:1 ratio is ob_
tained by mixing 3.2 ounces (95 ml) of oil with
1 gallon (4 liters) of unleaded gasoline.
DO NOT USE automotive oil or boat oil.
These oils will cause engine damage. When
mixing fuel, follow instructions printedon con_
tainer. Once oil is added to gasoline, shake
container momentarily to assure that the fuel
is thoroughly mixed. Always read and follow
the safety rules relating to fuel before fueting
your unit.
IMPORTANT
Experience indicates that alcohol blended
fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads to
separation and formation of acids during stor-
age. Acidic gas can damage the fuel system
of an engine while in storage.
Toavoid engine problems, empty the fuel sys*
tern before storage for 30 days or longer.
Drain the gas tank, start the engine and let it
run until the fuel lines and carburetor are
empty. Use fresh fuel next season.
Never use engine or carburetor cleaner prod-
ucts in the fuel tank or permanent damage
may occur.
See the STORAGE section for additional im
formation.
HOW TO STOP YOUR UNIT
• To stop the engine, push and release the
engine ON/STOP switch. The switch will
automatically return to the ON position.
Wait 5 seconds before attempting to restart
unit to allow switch to reset.
• If engine does not stop, move choke lever
to FULL CHOKE position.
Thrott'oT"0 11
HOW TO START YOUR UNIT
_WARNING:
The trimmer head will
turn while starfin_g the engine. Avoid any con-
tact with the muffler. A hot muffler can cause
serious burns.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
rting Position
J Starter Handle
Choke
-Lever
Primer
Bulb
Muffler
1. Set unit on a flat surface.
2. Slowly press the primer bulb 6 times.
3. Move choke lever to FULL CHOKE by
ali ning lever with position shown on de_
ca_(see illustration below).
Choke
position
decal
8
4. Squeeze the throffle tnggorfully and hold
through all remaining stega.
5. Pull starter rope handle sharply until en-
gine sounds as if it is trying to start, butdo
not pull rope more than 6 times.
6. As soon as engine sounds as if it is trying
to start, move choke lever to HALF
CHOKE by aligning lever with position
shown on decal (see illustration below).
Pull startar rope sharply until engine runs,
but no more than 6 pulls. If the engline
dcesn't start after 6 pulls (at the HALF
CHOKE position), move the choke lever to
the FULL CHOKE position and press the
pdmer bulb 6 times. Squeeze and hold the
throttle tdggor and pull the starter rope 2
more times. Move the choke lever to the
HALF CHOKE positionand pull the starter
rope untilthe engine runs,but no more than
6 pulls. If the engine doesn't start, repeat
prccedure 2 additional times.

Publicidad

loading