Assembly - Truper ASP-16S Instructivo

Assembly

• Pull out and from below the two latches to open the
vacuum cleaner and remove the container lid.
• Assemble the rear casters assembly (B) as shown.
Secure the axle, washers and casters by inserting the
retaining latches (C ) on both sides of the shaft. Push the
1
plugs (C ) until they are secure.
2
• Turn the container (D) upside down and install the two
front casters (E) and the rear casters assembly into their
respective mounts on the base of the container. Rotate
the container again to support the casters on the floor.
• Re-install the motor cover on the container until the
latches click.
• Install the transport handle on the two side mounts (F)
by inserting its ends through the respective holes until
the knobs (G) are secured.
• Install the fasteners (H) by inserting the carriage bolts
into the back of the handle and threading each into its
fastener. Make sure they face the same direction.
• Install the cartridge filter or foam filter depending on
the material to be vacuumed (see page 8).
CAUTION Remember to use the vacuum cleaner
with one of these filters installed, otherwise the motor
will be damaged and the warranty will be void.
• In case of vacuuming powders, fix the tab (I) of the
collection bag inside the vacuum port taking care not to
damage the bag.
I
• Insert the hose into the vacuum port (J).
• If necessary, connect one or more extension tubes to the free end of the hose.
• Choose the appropriate nozzle and connect it to the free end of the hose or, if necessary, to the extension tube (K).
• For quiet operation during vacuuming work install the noise diffuser in the blow-off port and turn it clockwise to secure it in
place (L).
J
G
H
C
1
B
C
2
E
D
G
F
K
L
ENGLISH
7