Autoadapt Turny Low Vehicle Manual De Instalación página 24

24
Turny Low Vehicle Getting seated
2
Place the application tool in the vehicle and align the part marked HORIZONTAL AREA
with the vehicle's direction of travel. This will ensure an optimal offset of 1 degree. The
recommended offset is 0-2 degrees. Next, adjust the brackets laterally. The distance be-
tween bracket and the centre of the OEM seat attachment must be between 15-45 mm for
installation to be stable. A distance of at least 15 mm will also ensure that the head of the
screw will not collide with the curvature of the bent leg when installing. With the aid of the
application tool, make sure there is sufficient space for the Turny Low Vehicle movement
paths. If necessary, the bracket closest to the door can be inverted laterally to achieve an
optimal position. The bracket closest to the transmission tunnel may not be turned round
otherwise it will end up within Turny Low Vehicle's crash segment.
As far as possible, endeavour to align the brackets as parallel as possible. This may mean that
the OEM seat attachment ends up on both sides of the bracket, which is a correct alterna-
tive solution.
All manuals and user guides at all-guides.com
1 ° offset
If necessary, the bracket closest to the door
can be inverted laterally. Recommended dis-
tances apply regardless of bracket location.
15 - 45 mm
OEM
3-6 cm
This part must abut
the B pillar to ensure
the best possible
freedom to swivel.