Autoadapt Turny Low Vehicle Manual De Instalación página 26

26
Turny Low Vehicle Getting seated
Adapt the console leg
1
Bend, twist and place the bracket legs based on the conditions that prevail in the
vehicle. The short part of the leg must however always be installed on the inside
or outside of the bracket. Allow the conditions in the vehicle combined with the
aesthetics to determine what is best. The design is very forgiving which simplifies
the adaptation since there is some adjustment range in the installing itself.
To achieve a stable construction the bracket legs are located as far apart as pos-
sible, out towards the short sides of the brackets. Begin by deciding leg location
and then bend or twist it towards the OEM seat attachment. Keep in mind that
the distance between the bracket and centre of OEM seat attachment must be
between 15-45 mm.
Example of adjusted brackets and bracket legs.
A
C
E
2
Drill holes in the dimensions which
are adapted for OEM seat attach-
ment. Centre the tool for the best
strength.
Adapted
All manuals and user guides at all-guides.com
Flat floor
Inclined floor 4°
Variable inclines
Drill holes for attaching the bracket. Use
the two-hole bolt as a template to mark
out the hole's position.
9 mm
Do not drill
through the bolt.
A / A bracket leg configured to reach an attach-
ment that is slightly to one side.
B / Configured bracket leg located on the inside
of the bracket such that it is not visible.
B
E / Configured bracket leg located on the outside
of the bracket.
D / Configured bracket leg used as a spacer be-
tween the mat and the bracket.
D
C / Configured bracket leg used to adjust the
height at the back of the bracket.
F
If option F is practised above, use the
three-hole bolt as a template to mark
out the hole's position.
Do not drill
through the bolt.
9 mm