Product Performance - Zonair3D Air+ 300 S Manual De Usuario

Product performance

Switching on and operating the Air+ 300S / 430 S
The equipment you have purchased is plug & play, which
means it does not need any prior configuration.
Before switching it on, check that you have all the
1
relevant components: cord and Air+ 300 S / 430 S air
purifier.
Locate a power socket to connect the Air+ 300 S / 430 S
2
and plug the unit into the socket using the power cord.
To switch the equipment on, double click on the power
3
button (ON / OFF) and the screen and its perimeter light
will illuminate.
Select speed mode and increase speed to maximum (10).
4
(See point 1, page 21).
After having checked its proper operation, it is
5
recommended to set the purifier at its maximum speed
during the first 10 minutes to execute a deep cleaning of
the room.
Then, it is recommended to leave it at medium speed,
6
below 5, to maintain optimal recirculation and comfort
speed.
7 To set automatic unit shutdown, use the timer button
(see point 2, page 21) and select the required operating
time, selecting the desired operating time.
The screen switches off automatically after 1 minute of
inactivity.
But, if you want to turn off the lights on the screen in that very
moment, click once on the ON / OFF button.
The proximity sensor detects the movement of your hand as it
passes over and turns the screen back on.
Switching off and disconection of Air+ 300 / 430 s
To switch off the unit, press and hold on the ON / OFF button
for 3 seconds.
If the purifier is not to be used for long periods, disconnect the
power cord.
Air+ 300 S & 430 S · Page 22