HC Cargo 211083 Manual De Instrucciones página 6

211083
Important
Please operate this function with schematic and correct testing procedure because applying voltage
arbitrarily may cause damage to components.
Trailer Light Test
To test the trailer light, you need to follow the procedure:
1. Connect the ground test lead to trailer ground.
2. Probe the tip to the outlet of the trailer;
push the polar switch forward, then technician can
diagnose the function of the trailer light.
Jumper Wire
Technician can also use this unit as a jumper wire. To do this, technician need to connect the
black power clip to the positive of the vehicle battery, and leave the red power clip disconnected.
Then technician can use the ground testing lead as the jumper wire.
Important
There is no short circuit protection as you use it as a jumper wire.
Voltage Test
Technician can also use this unit
assisting with ground test lead to test
the voltage of the circuit.
However, during the voltage test, please
do not push the polar switch.
Model NO Extension
lead
211083 6M (2 sets)
Use tip to apply positive voltage, which can
be helpful to diagnose the components
Press the switch rearward
Contact
with ground
Ground lead Cigarette
lighter adaptor
0,8M Rubber
adaptor
Motor
Probe with testing point
Hook-up clip
Rubber
adaptor
6
Extended
probe
1 pcs
Vedpak 227_Version 1_11.2019