ISOtunes LINK 2.0 Manual página 16

maintained for Bluetooth signal inputs which are standard to the
Bluetooth A2DP, HFP, and HSP specifications. There is no analog
line input on this product.
This earmuff is provided with electrical audio input. The wearer
should check correct operation before use. If distortion or failure
is detected, the wearer should refer to the manufacturer's advice.
For additional information about ISOtunes LINK 2.0, please visit
www.ISOtunes.com/pages/product-manuals. For additional
information or questions about ISOtunes® products or spares
and accessories, please contact our support team.
Replacement Parts: Hygiene Kit (ear-cushions and foam inserts)
Model Number: IT-83
Replace ear cushions.
1. Put your finger between the ear cushions and foam.
2. Pull the Foam Ear cushion away from the earcup.
3. Remove the foam inserts in the earcup.
4. Install the new foam inserts
5. Snap the new ear-cushion in place on the earcup
The following information shall be available from the
manufacturer on request:
a) results of tests performed in accordance with this standard;
b) the name and country of the test laboratory which performed
the tests specified and the date of the tests.
FCC
Caution: The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance could
void the users' authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This equipment complies with FCC's RF radiation exposure limits
set forth for an uncontrolled environment. End users must follow
the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
UK & Europe
uk-eurosupport@isotunesaudio.com
North America
support@isotunesaudio.com
1-844-396-3737
Monday-Friday 9-5 ET
The hearing protector provides safety-related audio input.
EN | 16