Agio 1900600 Manual Del Usuario página 8

5. After making any necessary adjustments to the alignment of the connector brackets, table
legs, and the firepit base frame, use the hex bolt driver to tighten all bolts . Repeat until all bolts
are tight. Do not over tighten. Over tightening may strip bolts.
6. Place the tabletop onto the assembled firepit base. Secure the tabletop to the firepit base by
using four 1/4"x40mm bolts and Ø20xØ6.5x1.0mm washers as shown in Figure 6. Hand
tighten only.
7. Place the burner pan protective ring into the firepan/burner assembly as shown in Figure 3.
Align the holes in the burner pan protective ring with the pre-drilled holes on the firepan/burner
assembly. Secure the burner pan protective ring to the firepan/burner assembly by using the
two M4 screws as shown in Figure 7.
8. Pour ALL the provided media (fire ice) into the burner pan. Burner MUST be completely
covered to ensure appliance function properly and safely. Remove any fire ice on top of the
ignition well. See Figure 8.
8
Figure 6
Figure 7
Figure 8