Maintenance And Inspection - EGAmaster 66556 Manual De Instrucciones

It is recommended to set the direction on the controller first, before setting screw removal,
which includes CW and CCW. Please refer to the following table for 9-level torque and speed
setting. The torque to remove screw should be larger than that to fasten screw. For detailed
controller setting, please refer to 66549 controller operating manual.
Controller:
Program setting
Direction
CW
CCW
CCW
CW
5) Attaching / detaching bit and bit type
Pull down the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely
attached and detached (single finger notion type) select such a bit whose shank is equal to the
size shown below.
6) LED Lighting auxiliary lighting
Please refer to the 66549 operation manual for setting adjustment.
7) Front Cover Thread: fixed auxiliary arm use.
8) Press-plate Start
Pressed down sensor screwdriver starts functioning when the switch trigger has been
pressed down; on the contrary, it stops when the screw has been tightened up or the trigger has
been released.
1. The sensor screwdriver must be operated in top condition, one day working hour must be
not more than eight hours.
2. Please note don't let the motor get over heated, every minute use 9 screws to operate.
3. The frequency use of this electric sensor screwdriver is over than eight hours a day, still it
needs periodically testing and treatment.
4. Inspect tool cords periodically and if damaged, have them repaired by an authorized service
facility. Inspect extension cords periodically and replace if damaged.
5. Do not remove any labels. Replace any damaged label.
6. To adjust the torque on these sensor screwdriver. Proceed as follows:
Stop the sensor driver first and adjust it with the 66549 controller.
Screwdriver light
signal (action)
Forward
Backward
Backward
Forward

MAINTENANCE AND INSPECTION

Controller setting
Edit work order
setting
Screw removal
setting
CW
CCW
CW
CCW
Screwdriver light
signal (action)
Forward
Backward
Forward
Backward
17