Tabla de contenido
Publicidad
Product conformance
How to recycle your equipment
The symbol shown here and on the packaging means
that the product is classed as electrical or electronic
equipment, so DO NOT put it in your normal garbage bin.
It's all part of the Waste Electrical and Electronic Equipment (WEEE)
directive to recycle products in the best way, and get rid of
dangerous things more safely.
You should contact your retailer, supplier, or local city office for
advice on how to dispose of this product in an environmentally
friendly way.
Reduction of hazardous substances
This product is compliant with the EU Registration, Evaluation,
Authorization and Restriction of Chemicals (REACH) Regulation
(Regulation No 1907/2006/EC) and the EU Restriction of Hazardous
Substances (RoHS) Directive (Directive 2011/65/EU).
Radio Equipment Directive (RED)
The KS-Series product is compliant with the
requirements of the Radio Equipment Directive
(2014/53/EU).
FCC statement
The KS-Series complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
The KS-Series has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
24
Product conformance
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
SAR Safety
FCC RF Exposure requirements: The highest SAR value reported
under this standard during product certification for use next to the
body with the minimum separation distance of 0mm is 0.741W/Kg.
This transmitter must not be collocated or operating in conjunction
with any other antenna or transmitter.
This product is compliance to FCC RF Exposure requirements and
refers to FCC website
https:/ /apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
search for FCC ID: 2AL26-KS2
All transmission frequencies of U-NII-1,U-NII-2A,U-NII-2C and
U-NII-3 comply with 47 CFR FCC Part15.407(g) and the
manufacturer declares that their transmission is maintained within
the U-NII-1, U-NII-2A,U-NII-2C and U-NII-3 bands.
25
Publicidad
Tabla de contenido
