Installation; Supplied Components; Start-Up; Connection Of The Power Supply - XS 70 Serie Manual De Instrucciones

Installation

 Supplied components
The instrument is always supplied inside the specific carrying case; the version without sensor is
always supplied with:
instrument with batteries, 5V adapter with USB cable, 1m S7/BNC connection cable, NT55 temperature
probe, buffer solutions in single-dose bottle and / or sachet, paper tissues, screwdriver, beaker, electrode
holder support -only for multi-parameter- multilingual user manual and test report.
There are versions with the sensor(s) already included. Contact your local distributor to be updated on the
correct composition of the sales kit.
 Start-up
 The device leaves the factory ready to be used by the user.
Batteries are included.

 Connection of the power supply
in addition to batteries, the instrument can be powered through electricity grid;

 check that the electrical standards of the line on which the instrumentation is to be installed comply
with the voltage and operating frequency of the instrument;
 use the original power supply only;
connect the power supply to the USB cable and the other end of the cable (Micro USB) to the Micro

USB port located on the front of the instrument;
Connect the power supply to an electric socket easy to reach.

ATTENTION - Danger of death or serious injury from electric shock.
Contact with live components can lead to injury or death.
Use the adapter supplied only.

Do not put the power supply in contact with liquids nor in a condensing environment.

 Avoid thermal shock.
 All electrical cables and connections must be kept away from moisture or liquids.
 Check that the cables and plugs are not damaged, otherwise replace them.
During use, do not cover the power supply and/or do not place it inside containers.

The electricity supply can be originated from the power grid and from the USB port of a PC too.
If the instrument is powered by PC, the icon indicating the battery status disappears from the display
Opening the DataLink+ software, on the display it is shown this icon
 Power on, date and time update, power off
Turn on the system by pressing the button
appears:
 model and firmware of the instrument;
 settings relating to the most important parameters and possible information about the DHS sensor;
 on first use, and after each battery replacement, the instrument during the start-up phase will request
the updating of the date and time.
 Using the directional keys, update the year and confirm with the key
operation with the month and day, and subsequently with hours and minutes.
UM Serie 70Vio EN rev. 1 04.06.2020
.
. The display initially activates all segments and then
10
.
. Carry out the same
EN