Apéndice A - Informaciones Sobre Certificaciones; European Directive Information; Hazardous Locations Approvals - SMAR FY301 Manual De Instrucciones

Apéndice A

European Directive Information

INFORMACIONES SOBRE
CERTIFICACIONES
Este apéndice reúne informaciones relativas a los certificados que cubren el equipo. Su contenido
fue generado por el Equipo de Certificación de Smar Equipamentos Industriais Ltda.
This product complies with following European Directive:
ATEX Directive (94/9/EC) –Equipment and protective systems intended for use in potentially
explosive atmospheres.
This product is certified according to the European Standards at NEMKO and EXAM (Former DMT).
The certified body for manufacturing quality assessment is Nemko (CE0470).
Consult www.smar.com for the EC declarations of conformity for all applicable European directives
and certificates.

Hazardous Locations Approvals

Warning: Explosions could result in death or serious injury, besides financial damage.
Installation of this instrument in an explosive environment must be in accordance with the national
standards and according to the local environmental protection method. Before proceeding with the
installation check the certificate parameters according to the environmental classification.
Notes:
Ingress Protection (IP)
Ingress protection (IP W): Supplementary letter W meaning special condition defined as

default by Smar the following: Saline Environment approved - salt spray exposed for 200
hours at 35ºC.
(Ref: IEC60529)
Ingress protection (Type X): Supplementary letter X meaning special condition defined as

default by Smar the following: Saline Environment approved - salt spray exposed for 200
hours at 35ºC.
(Ref: NEMA 250)
Marking Label
Once a dev ice labeled with multiple approval types is installed, do not reinstall it using any other
approval types. Scratch off or mark unused approval types on the approval label.
Maintenance and Repair
The instrument modification or replaced parts supplied by any other supplier than authorized
representative of Smar Equipamentos Industriais Ltda is prohibited and will void the Certification.
For Ex-d protection application
Only use Explosion Proof/Flameproof certified Plugs, Adapters and Cable glands.

As the instrument is non-ignition capable under normal conditions, the statement "Seal Not

Required" could be applied for Explosion Proof version regarding to conduits connection.
(CSA Approved)
In an Explosion-Proof/ Flame-Proof installation, do not remove the instrument housing covers

when powered on.

Electrical Connection
Use at least IP66 certified Ex-d metal cable gland and/or metal blanking plug for the electrical
connections in Explosion-Proof installations. Close properly any not used conduit, according
to the protection method. For water-proof applications all NPT thread parts apply the proper
water-proof sealant. (A non-hardening silicone group sealant is recommended).
A.1