Ebotics Code & Drive Manual De Instrucciones página 25

STEP 1
PIECES REQUIRED
1.1 As shown in picture 1, put the 2 line-follower sensors in the two middle holes of piece A. A
black piece should protrude from the bottom. Picture 1 shows a point of view from above.
1.2 Place the screws through the holes of the sensors. Use 2 screws for each sensor.
1.3 Use the nuts to tighten the screws from below.
All manuals and user guides at all-guides.com
X1
Piece A
X2
Line-follower sensors
Picture 1
X4
M3/12
CODE & DRIVE MANUAL
X4
NUTS
M3
25