SoundGate HONPDSDR Manual Del Usuario página 5

All manuals and user guides at all-guides.com
3 3
A A
XM2 Confi guration 1 (For vehicles without Rear-Seat
Entertainment or an external CD changer):
14-pin plug from the HONPDSDR Harness and replace it with the 14-pin male plug of the
HONSAT Harness. Connect the factory plug to the 14-pin female plug of the HONSAT Harness.
Using the included patch cable, connect the HONSAT cable (blue bullet plug) located on the
female plug of the HONSAT Harness to the HONPDSDR Harness.
3 3
B B
XM2 Confi guration 2 (For vehicles with Rear-Seat
Entertainment or an external CD changer):
disconnect the 14-pin factory plug at your satellite receiver and replace it with the 14-pin male
plug on the HONSAT Harness. Reconnect the factory plug to the 14-pin female plug on the
HONSAT Harness. Using the included patch cable, connect the HONSAT cable (blue bullet plug)
located on the male plug of the HONSAT Harness to the HONPDSDR Harness. For Acura vehicles
please see note 3 on the front page.
4 4
Mount all components.
the dash (mounting hardware not included). Be careful not to drill into
wiring or vehicle mechanisms. You are solely responsible for securely
fastening the HONPDSDR in your vehicle. Make certain that wires and cables cannot be damaged
by screws, clips or sharp, exposed pieces of metal.
Ensure that the HONPDSDR plug is in a convenient location for connection. Connect the included
cable for your iPod to the HONPDSDR module, then connect the other end to your iPod.
5 5
Using your iPod/iPhone.
you to control the functions of your iPod or iPhone through the controls
of your factory radio or navigation unit. To listen to your iPod, use the
appropriate button on your radio to choose CD, XM1 or XM2 input, selecting the one you've
chosen to emulate with the HONPDSDR.
The HONPDSDR may operate in one of two modes: SDR and Radio Interface (RI).
Using SDR mode will leave your iPod
displaying text
your iPod from your device or from the factory radio buttons and/or steering
control
wheel controls. This is an exclusive SoundGate feature you won't fi nd anywhere else!
When listening to music in SDR mode, once the end of a playlist is reached, playback will stop.
Press the SCAN button twice to re-initialize SDR mode and start playback from the beginning,
use the radio to select a new track/playlist, or, since your iPod is unlocked in SDR mode, simply
use your iPod to select a new playlist. When choosing a playlist in SDR Mode, use Playlist Down
to move backward alphabetically and Playlist Up to move forward.
INSTALLATION
unlocked
on the radio. The HONPDSDR
Disconnect the factory
Mount the HONPDSDR behind or under
OPERATION
The SoundGate HONPDSDR will allow
and available to use directly while
allows you to
also simultaneously
You MUST
still
5