Adjusting The Height Of The Extendable Rod; Brake System - m-cro MICRO FLEX Manual Del Usuario

asseMbly InstructIons

Adjusting the height of the extendable rod

1. Open the clamp
2. The extendable rod can now be set to the desired height. Pull the extendable rod up or push it
down until a locking button locks into an opening.
3. Then close the clamp again under tension (see Fig. M).
If no locking button is present or you would like a different height for the steering, the height of the
extendable rod can also be customised:
4. Tighten the knurled screw
so, make sure that the extendable rod is securely positioned and does not change height, even
when you put a lot of pressure on it.
If the clamp no longer achieves the desired closing effect, retighten the knurled screw by hand or
with the right hexagon socket key until it is properly closed again.

Brake system

Your MICRO SCOOTER has an innovative brake system. To activate brake, simply step on the rear
wheel brake with either of your feet.
13
CAUTION, RISK OF BURNING!
The brake fender gets very hot – avoid direct contact with your skin.
28
and push the locking button
12
with a hexagon socket key when the clamp is closed. While doing
11
inwards (see Fig. L).
10