DeWalt DW920 Serie Manual Del Usuario página 22

E N G L I S H
After approx. 4 hours, it will switch to maintenance
charge mode. The battery pack can be removed
at any time or left in the connected charger
indefinitely.
• The red charging indicator flashes rapidly to
indicate a charging problem. Reinsert the battery
pack or try a new one. If the new pack also
refuses to charge, have your charger tested by
an authorized D WALT repair agent.
E
• When plugged into power sources such as
generators or sources that convert DC to AC,
the red charging indicator may blink twice, switch
off and repeat. This indicates a temporary
problem of the power source. The charger will
automatically switch back to normal operation.
Inserting and removing the battery pack
• Insert the battery pack into the grip until it clicks
in place.
• To remove the battery pack, press the two
release buttons (8) simultaneously and pull the
pack out of the grip.
Inserting and removing bits (fig. A & B)
• Pull the sleeve (5) backwards and insert the
screwdriver bit (11).
• Release the sleeve.
• To remove the bit, pull the sleeve backwards and
pull the bit out of the holder.
Swivelling the tool head (fig. C)
The head of the tool can be swivelled for optimum
versatility.
• Press the release button (3).
• Swivel the tool head into the desired position.
• Release the button.
Selecting the operating mode or adjusting the
torque (fig. D)
The collar of this tool has 15 positions for the
adjustment of the torque to suit the size of the screw
and the workpiece material. For torque adjustment,
refer to the section «Screwdriving».
• Select the drilling mode or torque by aligning the
symbol or number on the collar (4) with the
indicator (12) on the housing.
en - 5
All manuals and user guides at all-guides.com
Forward/reverse slider (fig. E)
• To select forward or reverse rotation, use the
Instructions for use
Prior to operation:
• Make sure your battery pack is (fully) charged.
• Insert the appropriate bit.
• Select forward or reverse rotation.
Switching on and off (fig. E)
• To run the tool, press the variable speed switch (1).
• To stop the tool, release the switch.
• To lock the tool in off position, move the forward/
Screwdriving (fig. A)
• Select forward or reverse rotation using the
• Set the collar (4) to position 1 and begin
• If the clutch ratchets too soon, adjust the collar
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
forward/reverse slider (2) as shown (see arrows
on tool).
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Always observe the safety instructions
and applicable regulations.
The pressure exerted on the variable speed switch
determines the tool speed.
reverse slider (2) to the central position.
slider (2).
screwdriving (low torque).
to increase the torque as required.
WALT Power Tool has been designed to
E
18