What Is Included - Chauvet Professional Legend 330SR Spot Guía De Referencia Rápida

Ocultar thumbs Ver también para Legend 330SR Spot:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Legend™ 330SR Spot QRG
Contact
What is
Included
AC Power
AC Plug
Replacing the
Fuse
DMX Linking
DMX Connection
Lamp
Replacement
All manuals and user guides at all-guides.com
Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux, contact your
distributor
to
request
www.chauvetprofessional.com
·
Legend™ 330SR Spot
·
Neutrik® powerCON® power
cord
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Connection
Wire (U.S.)
AC Live
AC Neutral
AC Ground
Green/Yellow
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder cap
from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and
rating.
4.
Screw the fuse holder cap back in place and reconnect power.
The Legend™ 330SR Spot will work with a DMX controller using a regular
DMX
serial
connection.
www.chauvetprofessional.com.
The Legend™ 330SR Spot uses a regular DMX data connection for its DMX
personalities: Mode1 (21) and Mode2 (27). See the User Manual to connect
and configure for DMX operation.
1.
Turn the fixture off and disconnect it from power.
2.
Wait at least 15 minutes for the lamp to cool down.
3.
Remove back cover using the 2 Phillips-head ¼-turn screws.
4.
Take note as to the orientation of the lamp. Vent holes on the front of
the lamp should align horizontally with the air vents on the lamp
frame. Orient the rear of the product so that the fan is facing
downward.
5.
Using the lamp base, push the lamp down against the spring clips
located on the bottom, and then roll the lamp out the top.
6.
Remove the 2 wires connected to the lamp by the spade connectors.
7.
Reverse steps 3 thru 6 above to install the new lamp.
Please refer to the User Manual for more detailed instructions with
images.
support
or
return
for contact information.
·
2 Omega Brackets
·
Warranty Card
·
Quick Reference Guide
Wire (Europe)
Black
Brown
White
Blue
Green/Yellow
A
DMX
Primer
3
EN
a
product.
Visit
Screw Color
Yellow/Brass
Silver
Green
is
available
from

Publicidad

Tabla de contenido
loading

Tabla de contenido