Rear Panel - FONESTAR MA-400RGUZ Manual De Instrucciones

EN

REAR PANEL

Z1-Z2-Z3-Z4-Z5-COM: terminals to connect the loudspeaker lines in zones 1 to 5. In order to
1.-
activate/deactivate the zones use the front buttons. With the zone selection terminals only loudspeakers
with100 V line transformers must be used. The total connected power in loudspeakers must not exceed
the power of the amplifier. Connect the positive of each zone to the corresponding terminal Z1 to Z5
and the one common to all zones to the COM terminal.
VIN: terminal to make the zones function. If you wish to use the zones outputs, be sure to connect this
2.-
terminal to the 100 V or 70 V terminal.
3.- Loudspeaker output. For the connection of low impedance loudspeakers 4-8-16 Ω and high
impedance lines of 70-100 V. Connect the loudspeaker line between the COM terminal and the
impedance or line in volts (V) required. Use this loudspeaker output if the zones Z1-Z5 are not going
to be connected.
CHIME PRIORITY: musical chimes. By closing these contacts the chimes are played if the CHIME
4,-
button on the front panel of the amplifier is activated.
SIREN: siren. When these contacts are closed the siren signal is played.
5.-
INPUT 1 PRIORITY: input 1 priority through signal level. Close these contacts to activate priority of
6.-
INPUT 1. The rest of the inputs will be attenuated when a signal is detected in INPUT 1.
TEL. INPUT: telephone input terminals. Allow the connection of a telephone switchboard to make
7.-
announcements from a switchboard with priority over the rest of the inputs. Connect the switchboard
between the amplifier terminals HOT and COM. Consult the characteristics of the switchboard to adjust
it to the input level of the amplifier.
TEL. LEVEL: TEL. INPUT volume control. Allows adjustment of the volume of the telephone switchboard
8.-
which is connected to the terminals TEL. INPUT. Turning the knob clockwise increases the volume and
anticlockwise, reduces it.
FM: FM digital tuner aerial input.
9.-
10.- GND: screw for earth disconnection, to be used in the case of the plug not having it incorporated.
11.- Power supply voltage selector.
12.- AC power supply socket.
13.- LINE OUT: aux line output. To connect an amplifier, mixer, etc., 2 x RCA connectors.
14.- AMP IN/PRE OUT: the connection bridge between the 2 RCA connectors communicates the output
signal of the preamp (PRE OUT) with the input of the amplifier (AMP IN).
- 4 -