Rear Panel - FONESTAR MAZ-30RGU-E Manual De Instrucciones

EN

REAR PANEL

1.- 115 V/230 V: power supply voltage selector.
2.- FM: antenna input for the digital FM tuner.
3.- AC socket: for connection of the AC power cord.
4.- GND: grounding screw, to be used in the event that the electrical socket is not built-in.
5.- 12 V DC: 12 V DC supply terminals.These 2 terminals allow direct current supply by means of an external
source or 12 V DC batteries. Use a 2.5 mm2 cross-section cable to connect the - negative and + positive
terminals.
6.- Output for speakers. For connection of 4 Ω low impedance loudspeakers and 100/70/25 V high
impedance lines. Connect the speaker line between the COM terminal and the desired impedance or
line in Volts (V).
7.- AMP IN/PRE OUT: the connection bridge between the 2 RCA connectors communicates the signal
from the output of the preamp stage (PRE OUT) to the input of the amplifier stage (AMP IN).
8.- AUX/PHONO: signal input, 2 x RCA connectors.
9.- AUX/PHONO: allows you to select between auxiliary or phono input.
10.- PLAY/PAUSE REMOTE: to start and pause the replay.
INSTRUCTIONS FOR USE
FM TUNER
This model allows you to set FM radio stations.
To select the FM radio tuner as the sound source, press the MP3/FM button and choose the FM option.
Tuning of radio stations is done with the 7 and 8 buttons on the front panel. A short press of these buttons
automatically tunes to the previous (or next) frequency point. A long press of these buttons automatically
tunes to the previous (or next) digital FM station.
FM RADIO STATION MEMORY
Use the 7 and 8 buttons on the front panel to scroll to the desired station. Press the MEMORY button and
then one of the M1 to M4 buttons to store the selected station in that memory location.
SELECTING A MEMORISED STATION
With the digital FM tuner activated press one of the M1 to M4 buttons, which enables you to select one of
the preset stations.
- 4 -